Hydraulic Double Circuit Brake System Simulator

The simulator is composed of authentic elements from the braking system of a medium powered vehicle. The functioning is guaranteed by means of an electronic three phase 220V engine, which then transmits the motion to the front and rear wheels in two directions by means of a hydraulic engine. The servo brake is connected to a vacuum pump in order to simulate its motion. A range of manometers and taps allow for easy measurement and the ability to change pressure of the two systems (front and rear). The brake pedal is connected to a lever in order to measure the foot effort during the braking phase.

SPECIFICATIONS
* 2 Disk brakes connected to a constant-velocity joint
* 2 Drum brakes connected to axle shafts
* Double circuit hydraulic brake pump with tank
* Depressure servo brake with pedal
* Hand brake lever connected to rear drums
* Hydraulic diverter to reverse the spin direction
* Hydraulic ECU connected to a hydraulic engine in order to transmit the motion to the wheels
* A range of manometers to measure the tire pressures
* A range of taps to simulate circuit interruptions
* Vacuum pump for servo brakes
* Electronic three phase 220V engine

APPLICATIONS
* Practice brake system maintenance
* Test the efficiency of the braking system
* Simulate the front circuit failures
* Simulate the rear circuit failures
* Simulate the presence of water in the braking system
* Recognize servo brake presence
* Observe the functioning of the service brake
* Observe how temperature affects the efficiency of the braking system

WEIGHT AND DIMENSIONS
* Net Weight: ~100 Kg
* Gross Weight: ~200 Kg
* Dimensions: 120cm x 120cm x 150cm (L x W x H)